Filter
Top Products
10
11. Lubricate the M10 x 70mm Bolt (41). Attach the Leg
Lever (3) to the Front Leg (4) with the Bolt and an
M10 Nylon Locknut (49).
12. Insert a Pad Tube (17) through one hole in the Leg
Lever (3). Insert another Pad Tube through the other
hole in the Leg Lever. Insert the remaining Pad
Tube through the upper hole in the bracket on the
Front Leg (4).
Slide two Foam Pads (18) onto each Pad Tube (17).
13. Attach the Curl Pad (24) to the Curl Post (10) with
two M6 x 16mm Screws (45).
Slide the Curl Post (10) into the Storage Post (27).
14. Fully thread the M8 Nut (59) onto the M8 Eyebolt
(39). Insert the M8 Eyebolt through the hole in the
Weight Carriage (2) from the direction shown.
Tighten an M8 Nylon Locknut (40) onto the Eyebolt.
Be sure that there is a 2.1/2” Square Bushing
(58) in the top and bottom of the Weight
Carriage. (2)
14
11
12
13
39
58
59
58
40
2
45
4
3
49
41
Lubricate
24
27
10
18
18
18
4
3
17
17