Filter
Top Products
ASSEMBLY
2
47
40
42
40
4
5
40
42
20
5
6
7
1
1. Before assembling this product, be sure that
you have read and understand the information
in the box above.
Attach the Bench Frame (5) to the Front Leg (4)
with two M8 x 65mm Bolts (42), Support Plate A
(20), and two M8 Nylon Locknuts (40). Do not fully
tighten the Nylon Locknuts.
2. Place both sections of the Base (6, 7) on the floor.
Insert an M8 x 60mm Carriage Bolt (47) through
each section of the Base. Slide the Bench Frame
(5) onto the Carriage Bolts in the Base. Partially
tighten an M8 Nylon Locknut (40) onto each
Carriage Bolt but do not fully tighten the Nylon
Locknuts.
Insert two M8 x 65mm Bolts (42) through the Bench
Frame (5) and the sections of the Base (6, 7).
Partially tighten an M8 Nylon Locknut (40) onto
each Bolt but do not fully tighten the Nylon
Locknuts.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART attached at the center of the manual.
• As you assemble the weight bench, be sure that
all parts are oriented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) rubber mallet
• One (1) standard screwdriver
• One (1) phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
7