Filter
Top Products
11
15. Slide the Weight Carriage (2) onto the Lat Tower
(1). The Weight Carriage must be turned as
shown.
Slide the Carriage Stop (37) onto the Lat Tower (1).
The 2.1/2” Square Bushing (58) must be facing
the Weight Carriage (2). Align the holes in the
Carriage Stop with the indicated hole in the Lat
Tower. Attach the Carriage Stop to the Lat Tower
with the M8 x 70mm Bolt (38) and an M8 Nylon
Locknut (40).
16. Feed the Cable (36) through the indicated slot in
the Lat Tower (1). Rest the Cable in the groove of a
Pulley (35). Attach the Pulley to the Lat Tower with
a 10mm x 75mm Bolt (50), two 10mm Washers
(51), two 16mm Spacers (52), and a 10mm Nylon
Locknut (49).
Rest the Cable (13) in the groove of the other
Pulley (35). Attach the other Pulley to the Lat Tower
(1) with a 10mm x 75mm Bolt (50), two 10mm
Washers (51), two 16mm Spacers (52), and a
10mm Nylon Locknut (49). The Cable must run
smoothly over both Pulleys.
Attach the Cable (36) to the M8 Eyebolt (39) by
sliding the loop on the end of the Cable onto the
hook of the Eyebolt.
15
16
Align
These
Holes
1
2
38
37
58
40
35
36
52
51
35
49
1
Slot
39
52
50
51