Filter
Top Products
13
Programmable Console
PART 2
SPECIAL CONSOLE FEATURES
(Models X6200, X6200HRC)
Manual Start
If you wish to skip all programming steps, simply press START•STOP while all six program lights are
flashing. The console will go to Manual Program, Level 6 and begin in count up mode. To change lev-
els, press the UP or DOWN arrow.
Easy Start
Each Program has a ‘default’ Program Level. If a Program Level is not entered, then the Program will
operate on Program Level 6. If you choose to use the default Program Level of 6, the preset program
times and the preset weight of 150 lbs, you can press the START•STOP button immediately after choos-
ing the Program and the Program will begin.
OR, if you choose to use the preset program time and the preset weight of 150 lbs, but want to cus-
tomize only the Program Level, you can press the START•STOP button immediately after choosing the
Level and the Program will begin with your selected Level.
Change Course Difficulty
Once the Program has begun, you can vary the level of each segment by using the UP or DOWN
arrow. This feature allows you to adjust select sections of a course to meet your present fitness level.
If you wish to vary the Level of the entire Program, you must stop the Program you are in and start
over.
Pause
You may stop a Program after it has begun by pressing the START•STOP button once. To resume the
Program, press the START•STOP button again.
Reset
After a Program has begun, you may quit the Program by pressing and holding the START•STOP but-
ton for 2 seconds. The column of red program lights will flash and the console profile screen will show
the Manual Program.
Auto-Reset
If your Vision Fitness Elliptical Trainer is not used for 5 minutes, it will automatically reset itself. (Auto-
reset will not work when timer is operating
in count up mode.)