Filter
Top Products
3
HARDWEAR IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the end of the bolts,
or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
NOTE: The length of all bolts and screws except those with flat heads is measured
from below the head to the end of the bolt or screw. Flat head bolts and
screws are measured from the top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware
may be already attached to the part.
Part No. and Description Q’TY
66 Lock Washer (M8) 4
70 Washer (8x38x2.0t) 4
80 Screw, Round Head (M5xp0.8x15mm) 18
81 Screw, Round Head (M5xp0.8x50mm) 2
83 Bolt, Socket Head (M8xp1.25x10mm) 8
90 Bolt, Button Head (M10xp1.5x85mm) 2
94 Bolt, Hex Head (M8xp1.25x65mm) 4
95 Bolt, Hex Head (M10xp1.5x50mm) 2
104 Nylon lock Nut (M10xp1.5) 2
105 Nut Cap 2