Filter
Top Products
-8-
M1036 Micro Mill
ELECTRICAL
ELECTRICAL
110V Operation
When it is necessary to use an extension cord, use the
following guidelines:
• Use cords rated for Standard Service
• Never exceed a length of 100 feet
• Use cords with 16 ga. wire or bigger
• Ensure cord has a ground wire and pin
• Do not use cords in need of repair
Extension Cords
Grounding
This machine must be grounded! The electrical cord sup-
plied with this machine comes with a grounding pin. Do
not remove it. If your outlet does not accommodate a
ground pin, have it replaced by a qualified electrician or
have an appropriate adapter installed.
Note: When using an adapter, the adapter must be
grounded.
The SHOP FOX
®
Model M1036 is prewired for 110 volt
operation. The motor supplied with your new Micro Mi
ll
is rated at
0.2 HP and will draw approximately 2 amps. A
5-15 plug is included for your machine and is intended to
be plugged into a matching
5-15 receptacle.
Connect your machine to a circuit (wire, breaker, plug,
receptacle) that is rated for at least
10 amps.
Keep in mind that a circuit being used by other machines
or tools at the same time will add to the total load
being applied to the circuit. Add up the load ratings
of all machines on the circuit. If the total amp load
exceeds the rating of the circuit breaker or fuse, use a
different circuit.
Figure 2. Typical 110V 3-prong plug and
outlet.
This equipment must be grounded.
Verify that any existing electrical out
-
let and circuit you intend to plug into
is actually grounded. If it is not, it will
be necessary to run a separate 12 AWG
copper grounding wire from the outlet
to a known ground. Under no circum-
stances should the grounding pin be
removed from any three-pronged plug
or serious injury may occur.