Filter
Top Products
ASSEMBLY
Assembly requires two persons. Place the treadmill in a cleared area and remove all packing materials. Do not
dispose
of the packing materials until the treadmill is assembled.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or
the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires a phillips screwdriver , a rubber mallet , and wire
cutters (not included).
1. Cut the plastic ties (not shown) from the sides of the
treadmill.
With the help of a second person, carefully
raise the Uprights (65) until the Wheels (not shown) are
resting on the floor.
Hold the Book Plate (114) against the back of the
Console Base (117) and the tube on top of the Uprights
(65), as shown. Attach the Book Plate with four 3/4”
Screws (40).
114
40
65
117
40
1
2. Insert one of the Handrail Extensions (76) into the post on
the left side of the Uprights (65). Make sure that the
notch in the Handrail Extension is in the position
shown. Align the holes in the Handrail Extension with the
holes in the post. If necessary, use a rubber mallet to fully
insert the Handrail Extension. Attach the Handrail
Extension to the post with four 1/2” Screws (74).
Identify the Left Foam Grip (62), which has a hole in the
right side. Slide the Left Foam Grip as far as possible
onto the Handrail Extension (76) and the post. (Note: It
may be helpful to apply soapy water to the Handrail
Extension
.) Press two Plastic Fasteners (75) into the bot
-
tom of the Left Foam Grip and the Handrail Extension.
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (not shown) to the post on the right side of
the Uprights (65) in the same way. Note: There is not a hole
in the side of the Right Foam Grip.
Identify the Left Cup Holder (128); the lower edge is nar-
rower on the left side. Press the Left Cup Holder into the left
side of the Book Plate (114). Press the Right Cup Holder
(not shown) into the right side of the Book Plate.
74
Notch
Hole
74
Post
Lower Edge
65
128
114
76
62
75
2
6
40
74