Filter
Top Products
11. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill. If there is a sheet of
clear plastic on a decal, remove the plastic
.
9
10. Attach the Left Upper Body Arm (95), which is labeled
with a sticker, to the Left Upright (111) with two 1/4” x
3 1/2” Bolts (123), two Washers (122), and two 1/4” Star
Washers (93) as shown. Note: Make sure that the Left
Upper Body Arm is on the correct side of the handgrip
pulse sensor (see the drawing on page 5).
Attach the Right Upper Body Arm (not shown) to the
Right Upright (not shown) in the same way.
111
123
93
10
122
95
9. Lower the Uprights (111, 119) until the Handrails (108,
120) are touching the floor. Note: If necessary, pull out
on the latch knob so the pin does not hit the Frame (21).
See the lower drawing. Position the Uprights (111, 119)
so that the treadmill Frame (21) is centered between the
Uprights.
Firmly tighten the four Upright Bolts (133). Then, raise
the Uprights (111, 119) back to the vertical position.
Note: If necessary, pull out on the latch knob so the pin
does not hit the Frame (21).
133
111
119
9
111, 119
Latch
Knob
108, 120
21
21
8. With the help of another person, hold the console as-
sembly near the Right Upright (119) and the left Upright
(
not shown).
C
onnect the Wire Harness (118) to the wire harness in
the console assembly. Make sure to connect the con-
nectors properly (see the inset drawing); the con-
nectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try again. IF
THE CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Insert the excess wire
harness back into the Right Handrail (120).
Set the console assembly on the Right Upright (119) and
the Left Upright (not shown). Thread two 1/4” x 1” Bolts
(117) with 1/4” Star Washers (93) into each side of the
console assembly. After you have started all four
Bolts, tighten them.
119
120
C
onsole
A
ssembly
118
93
117
118
8
Right Handrail