Filter
Top Products
22
THE INFORMATION MODE/DEMO MODE
T
he console features an information mode that keeps
track of the total number of hours that the treadmill has
b
een operated and the total number of miles that the
walking belt has moved. The information mode also al-
lows you to select miles or kilometers as the unit of
measurement and to turn on and turn off the demo
mode.
To select the information mode, hold down the Stop
button while inserting the key into the console. Next,
release the Stop button. When the information mode is
selected, the following information will be shown in the
displays:
The left display will show
the total number of hours
that the treadmill has been
used.
The right display will show
the total number of miles (or
kilometers) that the walking
belt has moved. In addition,
an “E” for English miles or
an “M” for metric kilometers
will appear in the right display. Press the Speed in-
crease button to change the unit of measurement if de-
sired.
IMPORTANT: If a “d” appears in the right display, the
console is in the “demo” mode. This mode is intended
to be used only when a treadmill is displayed in a store.
When the console is in the demo mode, the power cord
can be plugged in, the key can be removed from the
console, and the indicators in the displays will automati-
cally appear in a preset sequence, although the but-
tons on the
console will
not
operate.
If a “d” appears
when the information mode is selected, press the
Speed decrease button so “d” disappears.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
A
n optional chest pulse sensor offers hands-free oper-
ation and enables you to use the console’s two pulse
p
rograms.
T
o purchase the optional chest pulse
sensor, call the toll-free telephone number on the
front cover of this manual.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the 3/4” Screw (33) and the Access Door
(105) from the Console Back (104).
2.
Connect the wire on the receiver (A) to the indicated
wire extending from the Console Back (104).
Remove the paper from the adhesive pad on the
back of the receiver. Hold the receiver so the
small cylinder is near the lower edge of the re-
ceiver and is facing the Console Back as shown.
Firmly press the receiver onto the indicated corner
of the Access Door (105). Note: If there are two
screws included with the chest pulse sensor and
two plastic posts on the inside of the Access Door,
attach the receiver to the plastic posts on the
Access Door with the two screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (105) with the 3/4” Screw (33). The
other wires included with the receiver may be dis
-
carded.
A
104
105
Cylinder
33
Wire