ProForm PFTL54706.0 Treadmill User Manual


 
8. See drawing 8a. If there is a guard on the end of
the Console Wire, press the indicated tab and re-
move the guard with needlenose pliers. Discard
the guard.
With the help of a second person, hold the Console
Assembly (91) near the Right Upright (54).
Remove the wire tie from the Wire Harness (39).
Connect the Wire Harness to the console wire
harness.
Make sure to connect the connec-
tors properly (see drawing 8b). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors and the ex-
cess wire downward into the Right Upright (54).
8
91
54
39
Console Wire
Harness
39
9
7
. Set the Console Assembly (91) face down on a
soft surface to avoid scratching the Console
Assembly. Hold the Right Handrail (33), which
has a large hole in one side, near the Console.
Next, insert the console wire and the tie into the
hole in the side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.
Then, set the Right Handrail (33) on the Console
Assembly (91).
Make sure that no wires are
pinched. Start a Crossbar Screw (85) with a
Crossbar Star Washer (7) into the Right
Handrail, and then start two Console Screws
(10) into the Right Handrail.
Tighten the
Crossbar Screw and then tighten the two
Console Screws; do not overtighten the
Screws.
Attach the Left Handrail (not shown) to the
Console Assembly (91) in the same way. Note:
There are no wires on the left side.
7
Console
Wire
Large
Hole
3
3
Bracket
85
7
10
91
8b
9. Attach the Console Assembly (91) to the Right
Upright (54) and the Left Upright (53) with four
four Handrail Bolts (8) and four Handrail Star
Washers (5). Make sure that no wires are
pinched. Start all four Handrail Bolts but do
not tighten them yet.
9
8
8
5
5
91
54
53
Tie
Guard
Tab
8a
Console
Wire