ProForm PFTL54706.0 Treadmill User Manual


 
THE INFORMATION MODE
T
he console features an information mode that keeps
track of treadmill usage information. The information
m
ode also allows you to select miles or kilometers as
the unit of measurement and to turn on and turn off the
demo mode.
When the information mode is selected, you can also
choose an audio setting for your cross training workouts.
To select the information mode, hold down the Stop but-
ton, insert the key into the console, and then release the
Stop button. When the information mode is selected, the
following information will appear in the display:
The lower right part of the display will show the total
number of miles or kilometers that the walking belt has
moved. The lower left part of the display will show the
total number of hours that the treadmill has been oper-
ated. In addition, the word “ENGLISH” for miles or the
word “METRIC” for kilometers will appear in the upper
left part of the display. To change the unit of measure-
ment, press the Speed increase button.
When you use a cross training program, a personal
trainer can guide you through your workouts; you can
select any of three audio settings while the information
mode is selected. In the center of the upper part of the
display, an “I” (for Instruction), an “N” (for No), or a “Y”
(for Yes) will appear. When “I” is selected, the voice of
a personal trainer will guide you through your workouts
and give detailed instructions. When “N” is selected,
you will not hear the voice of the personal trainer.
When “Y” is selected, the voice of the personal trainer
will guide you through your workouts but will not give
detailed instructions. Press the Incline decrease button
to change the audio setting if desired.
IMPORTANT: If the words “DEMO ON” appear in the
display, the console is in the “demo” mode. This mode
is intended to be used only when a treadmill is dis-
played in a store. When the console is in the demo
mode, the power cord can be plugged in, the key can
be removed from the console, and the indicators in the
display will automatically appear in a preset sequence;
the buttons on the console will not operate.
If “DEMO
ON” appears when the information mode is se
-
lected, press the Speed decrease button so that
“DEMO OFF” appears.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers hands-free oper-
ation as it tracks your heart rate during your workouts.
To purchase the optional chest pulse sensor, call
the toll-free telephone number on the front cover
of this manual.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Console Screw (4) and the
Access Door (73) from the back of the Console (91).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console (91). Hold the re-
ceiver so the small cylinder is oriented as
shown and is facing the Console Back. Attach
the receiver to the plastic posts on the Access Door
(73) with the two included small screws.
3.
Make sure that no wires are pinched. Reattach
the Access Door (73) with the Console Screw (4).
Discard the other wires included with the receiver.
20
A
91
Small
Cylinder
4
73
Wire
Small
Screws