ProForm PFTL54706.0 Treadmill User Manual


 
7
2. Have a second person hold the Base (52) in the
position shown.
Identify the Left Upright (53) (the Right Upright [54]
h
as a large hole near the lower end).
Hold the Left Upright (53) so the two small
holes for the latch assembly are on top as
shown. Insert two Upright Bolts (2) into the
bracket on the Left Upright. Attach the Left
Upright to the Base (52) with the Upright Bolts,
two Upright Star Washers (9) and two Nuts (16).
Do not tighten the Nuts yet.
Attach the Right Upright (54) to the Base (52) in
the same way.
2
52
53
16
2
2
16
9
9
9
9
54
Large
Hole
Small Holes
3. Slide the two Wheel Housings (45) onto the Base
(52). Attach each Wheel Housing with two Wheel
Housing Bolts (13), two Wheel Housing Washers
(32), and two Wheel Housing Nuts (43).
3
52
13
32
32
45
43
13
32
32
45
43
4. Position the Base (52) as close to the front of the
treadmill as possible, as shown.
See drawing 4a. Locate the wire tie in the lower
end of the Right Upright (54). Tie the wire tie se-
curely around the end of the Wire Harness (39).
Then, locate the other end of the wire tie in the
upper end of the Right Upright. Pull that end of
the wire tie until the Wire Harness is extending
from the upper end of the Right Upright. Secure
the Wire Harness to the Right Upright so that it
will not fall inside.
See drawing 4b. Press the indicated Grommet
(49) into the Right Upright (54).
52
4
39
54
54
54
49
39
52
Wire Tie
4b
4a
39