Filter
Top Products
ASSEMBLY
T
o hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly requires
two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the pack-
ing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walk-
ing belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lu-
bricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver , rubber
mallet , and adjustable wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached
to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assem-
bly. Extra hardware may be included.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its side as shown. Partially fold
the Frame (55) so that the treadmill is more sta-
ble. Do not fully fold the Frame until the
treadmill is completely assembled.
Insert a Base Extension (97) into the indicated
bracket on the base of the Uprights (85). Make
sure that the Base Extension is turned so the
Base Foot (81) is on the side shown. If neces-
sary, use a rubber mallet to align the holes in the
Base Extension with the holes in the bracket.
Attach the Base Extension (97) with two 5/16" x
2" Bolts (87), two 5/16" Star Washers (110), and
two 5/16" Base Extension Nuts (91) as shown.
Firmly tighten the Bolts.
#8 x 3/4" Screw
(7)–6
5/16" Star
Washer (110)–4
5/16" Base Extension
Nut (91)–4
3/8" Star
Washer (67)–4
3/8" Nut (20)–2
#8 x 2 1/4" Screw (63)–4
#8 x 1" Tek Screw
(82)–8
5/16" x 2" Bolt (87)–4
3/8" x 1 1/4" Bolt
(72)–4
3/8" x 1 3/4" Bolt
(109)–2
85
Bracket
81
55
87
91
1
110
97
7