Filter
Top Products
10
9. Attach the console assembly to the Uprights
(85) with four 3/8" x 1 1/4" Bolts (72) and four
3/8" Star Washers (67) (only one side is shown).
Start all four Bolts before tightening any of
them.
67
72
85
Console
Assembly
9
8. Remove the band securing the TV Cable (112) to
the left Upright (85). Connect the TV Cable to
the cable extending from the console assembly.
Then, insert the cables into the left Upright.
Next, insert the brackets on the Handrails (70)
into the Uprights (85). Make sure that no wires
are pinched.
70
Bracket
112
85
Console
Assembly
8
7. Remove the band securing the Upright Wire (73)
to the right Upright (85). Have a second person
hold the console assembly near the right Upright.
Connect the Upright Wire (73) to the wire harness
on the console assembly. See the inset draw-
ing. The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON. Then, insert the
connectors into the right Upright (85).
73
85
Console
Assembly
73
7
Wire
Harness
Cable
Wire
Harness