Filter
Top Products
9
5. Identify the Left and Right Base Covers (96, 97).
Slide the Left Base Cover (96) onto the Left
Upright (90). Slide the Right Base Cover (97)
onto the Right Upright (99). Do not press the
Base Covers into place yet.
90
96
99
97
5
4
. Hold the Left Upright (90) against the Base
(105). Be careful not to pinch the wires. If
necessary, position the Base Ground Wire
(100) in the hole in the side of the Left Upright.
I
nsert two 3/8" x 2 3/4" Screws (8) and two 3/8"
x 1 1/4" Screws (9) with two 3/8" Star Washers
(14) into the Left Upright.
P
artially tighten the 3/8" x 2 3/4" Screws (8) and
the 3/8" x 1 1/4" Screws (9) until the heads of
the Screws touch the Left Upright (90); do not
fully tighten the Screws yet. Note: It may be
helpful to use the Short Hex Key (43) on the
Screw shown.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the
right side.
90
105
4
9
8
14
Hole
100
14
43