Filter
Top Products
11
9. Remove and discard the #10 x 3/4" Screws (3)
from the Right Handrail (93) and the Left
Handrail (not shown).
H
old the pulse assembly near the Right Handrail
(93). Insert the pulse wire from the pulse assem-
bly into the hole in the side of the Right Handrail
and out of the end of the Right Handrail as
s
hown.
93
Hole
P
ulse Wire
9
10. Slide the pulse assembly onto the Left and Right
Handrails (92, 93). Make sure the brackets on
the pulse assembly are flush against the rub-
ber on the Handrails. Be careful not to pinch
the pulse wire against the pulse assembly.
Attach the pulse assembly with four #10 x 3/4"
Screws (3) and four #10 Star Washers (11).
Start all four Screws, and then tighten them.
10
11. Set the console assembly face down on a soft
surface to avoid scratching the console
assembly.
Identify the Left and Right Trays (110, 111).
Attach the Trays (110, 111) to the console as-
sembly with six #8 x 1/2" Screws (1). Start all
six Screws, and then tighten them. Be care-
ful not to overtighten the Screws.
Remove the four 5/16" x 5/8" Screws (4) and
5/16” Star Washers (12) from the console as-
sembly. They will be used in step 13.
1
1
4
4
Console
Assembly
1
110
111
1
12
12
11
3
3
11
Pulse
Assembly
3
11
92
93
Pulse
A
ssembly
Pulse Wire