ProForm 2400 Treadmill User Manual


 
18. Lower the Frame (64) (see HOW TO LOWER
THE TREADMILL FOR USE on page 29).
If one of the Rear Leveling Feet (69) doesnʼt sit
flat on the floor, turn the Rear Leveling Foot until
it does, and then tighten the 1/2" Rear Leveling
Foot Nut (41) against the Frame (64). Make
sure that both 1/2" Rear Leveling Foot Nuts
are tightened against the Frame.
18
64
69
41
14
17. Attach the upper end of the Storage Latch (65)
to the Frame (64) with a 3/8" x 1 3/4" Bolt (7)
and a 3/8" Nut (13). Note: It may be necessary
to move the Frame back and forth to align the
S
torage Latch with the Base (not shown).
1
7
65
13
64
7
19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to
adjust the walking belt (see pages 31 and 32).