Filter
Top Products
page 43
COMMERCIAL PRODUCTS DIVISION
Take the following steps to align the running belt on the treadmill. To ensure your
safety, make all adjustments while the treadmill is OFF.
1. Make sure the treadmill is OFF and the running belt has completely stopped.
2. Locate the right belt adjustment bolt in the rear end cap of the treadmill.
(To determine left and right, stand at the rear of the treadmill and face the
display.) See Diagram 21. The direction you turn the bolt depends on how
the belt is tracking. Make all belt adjustments on the
right rear corner bolt
using the hex key provided.
• If the belt is off center to the RIGHT, turn the adjusting bolt 1/4 turn
clockwise, which moves the running belt to the left.
• If the belt tracks off center to the LEFT, turn the bolt 1/4 turn
counter-
clockwise
; this moves the belt to the right.
Important: Do not turn the adjusting bolt more than 1/4 turn at a time.
Over-
tightening the bolt can damage the treadmill
.
3. Turn ON the treadmill, press Quick Start, and then increase the running belt
speed to 3 mph (5 kph) by pressing Speed ▲.
CAUTION: Stand to the side of the treadmill. The running belt begins
moving automatically after you press QUICK START.
4. Observe the running belt for a couple of minutes. The belt should be centered on
the running bed. A few inches from either side of the side rail platform.
CAUTION: If you hear any chafing or the running belt appears to be
getting damaged, stop the running belt immediately by pressing the
red Stop key. Contact Precor Customer Support.
5. If the belt needs additional alignment, repeat steps 1 through 4 of this proce-
dure until the belt is properly aligned.
6. Press Stop. To return to the Precor banner, press Reset.
Diagram 21
Align the
running belt.
Adjust the bolt
using a 5/16-inch
hex key.
Side rail
Running belt
Right side rear
end cap
Pat,
Please
double-check
that these
instructions
are accurate.
Thanks!