Filter
Top Products
page 42
COMMERCIAL PRODUCTS DIVISION
Maintenance
The C956 or C954 requires little maintenance to keep it running smoothly and
efficiently. However, you, as club manager or owner, are responsible for typical
maintenance tasks such as, cleaning the unit to keep it free from dust and dirt
accumulation. If you fail to maintain the treadmill as described below, it could
affect or void the Precor limited warranty.
CLEANING THE EQUIPMENT
DANGER — TO REDUCE THE RISK OF ELECTRICAL SHOCK, ALWAYS UNPLUG THE UNIT FROM ITS
POWER
SOURCE BEFORE CLEANING IT OR PERFORMING ANY MAINTENANCE TASKS.
Most of the working mechanisms are protected inside the treadmill’s hood and
solid base. However, for efficient operation, the treadmill relies on low friction. To
keep the friction low, the treadmill must be as clean as possible.
It is recommended that the running bed and belt be cleaned daily. Use a damp,
soft cloth to clean the staging platform, running bed and between the belt and
running bed surface as far as you can easily reach. This removes any dust or dirt
which might affect the smooth operation of the unit.
CAUTION: Never pour water or spray liquids on the display console, hand-
rails, or treadmill. Allow the treadmill to dry completely before using.
Periodically, clean the treadmill’s frame, display console, handrails and running belt
with a dampened (not dripping wet),
clean
cloth using a diluted solution of Simple
Green
®
. To clean the grooves on the belt, use a soft nylon scrub brush. Vacuum the
floor underneath the unit every week to prevent the accumulation of dust and dirt.
The Precor Heart Rate equipment requires little maintenance beyond keeping it
dust free. Dampen a sponge or soft cloth in mild soap and water to wipe the
POLAR
®
chest strap. Dry the surface thoroughly with a clean towel.
ALIGNING THE RUNNING BELT
The correct alignment of the running belt is critical to the smooth operation of the
treadmill. The belt is properly aligned at the factory. However, during shipping and
handling or by use on an uneven surface, the belt may move off center and
require a few simple adjustments.
Before aligning the running belt, check its operation by following the procedure in
Checking the Alignment of the Running Belt
on page 19. If you determine that the
belt needs alignment, follow the instructions here.
CAUTION: Special care must be taken when aligning the running belt. Turn
OFF the treadmill while adjusting or working near the rear roller. Remove
any loose clothing and tie back your hair. Be very careful to keep your finger
or any other object clear of the belt and rollers, especially in front of the
roller and behind the deck. The treadmill will not stop immediately if an
object becomes caught in the belt or rollers.
Realigning the belt takes a few simple adjustments. If you are unsure about this
procedure, call Precor Customer Support (see
Obtaining Service
on page 7.)