Filter
Top Products
page 11
COMMERCIAL PRODUCTS DIVISION
You do not need any special knowledge or experience to set up a C764 climber,
however you will need assistance. Ask for one or more assistants to help you
assemble the climber.
INSTALLATION REQUIREMENTS
Follow the installation requirements below when installing the climber.
If you do
not install the climber according to the following guidelines, you could void the
Precor limited warranty.
• Set up the C764 climber on a solid, flat surface. A flat surface is required
for your safety and proper use of the climber.
• Fill out and mail the limited warranty card. The serial number is located on
a label near the power receptacle.
• Use the appropriate voltage, dedicated circuit, and grounding as speci-
fied on the climber. The C764 climber is available in a 120-volt model in the
U.S.A. and Canada. A 240-volt model is available for the European and
international markets. Refer to the climber’s identification label to determine
the voltage that your climber requires. The C764 climber’s 120-volt and 240-
volt models require a dedicated 15 amp circuit. A 20 amp dedicated circuit
is recommended. Failure to use a dedicated circuit might damage the unit and
void the manufacturer’s limited warranty.
CAUTION: Do not use a non-grounded outlet. Do not remove or otherwise
bypass the plug with an adapter. Electrical damage can occur if the C764
climber is connected to an improper power source.
ADDITIONAL TOOLS NEEDED
Obtain the following tools before assembling the C764.
❏ Standard set of hex keys
❏ ½-inch socket wrench with an extension
❏ ½-inch box-end wrench or crescent wrench
❏ ⁷₁₆-inch box-end wrench
ASSEMBLY INSTRUCTIONS
To assist you in the assembly of the climber, the items in the hardware kit, shown
in Diagram 2, correspond to a particular letter in the alphabet. These letters
appear throughout the assembly instructions. Refer to Diagram 2, while perform-
ing the following steps:
1. Unpack the climber and remove the packing materials from the handrails,
upper column support, display console, handlebars, and base frame
assembly.
CAUTION: To avoid injury and ensure your safety, you need assis-
tance to lift the climber off the pallet and place it on the floor. Do not
drop the unit.
Setting Up the C764 Climber