Filter
Top Products
page 7
5. Secure the mounting bracket and clamp by inserting
the two long screws through the mounting holes. You
may need to squeeze the ends of the clamp together to
install the screws. See Diagram 3. Tighten the screws
into the recessed holes on the mounting plate using
the Phillips head screwdriver. Do not over tighten the
screws. A gap should remain between the opposite
sides of the handrail clamp.
Diagram 4
6. Unwrap the reed switch wire. Route the connector and
wire through the hole in the handrail clamp. See
Diagram 4.
7. Plug the connector into the receptacle as shown in
Diagram 4. Do not force the connection. The
connector is designed to engage in one direction only.
A tab on the connector and a slot on the receptacle
help you determine the proper alignment.
8. Align the back of the console with the mounting
bracket and slide the electronic console onto it. Gently
pull the excess wire through the hole in the handrail
clamp while you slide the console toward the rear of
the treadmill.