Filter
Top Products
page 12
Installing the Mounting Pads
Two adhesive-backed foam pads (one thick and one thin
pad) accompany your electronics option package. The thick
pad is used as a spacer and you place the reed switch on it.
The thin pad is positioned onto the flywheel and becomes
the base for the magnet.
CAUTION: Both pads require a 24-hour period to bond
properly to the equipment. Do not operate the treadmill
during this time.
Diagram 9
Place mounting
pad here
To install the mounting pads to the flywheel and side rail on
your 903 or 904 treadmill, take the following steps:
1. Locate the area on the side rail between the right roller
guard and the deck of the treadmill. See Diagram 9.
Note: Right and left are determined by standing
behind the rear roller and facing the handrail(s).