Filter
Top Products
page 16
Diagram 13
5. Remove the paper to expose the adhesive strip that is
on the foam mounting pad. Press the reed switch onto
the pad. Be sure that the reed switch is positioned so
that the wires are easily routed up the handrail. See
Diagram 13.
6. Rotate the flywheel by hand to make sure that the
magnet and reed switch are secure and are not
rubbing on each other or on the treadmill. Check that
the reed switch wire is clear of the flywheel. If the
magnet and flywheel are not correctly aligned you may
get incorrect readings on the display. Reposition the
magnet and reed switch if necessary.
7. Secure the handrails into an upright position.
8. Check the wires to be sure no excessive amount of
wire hangs down where it could cause entrapment or
injury to someone. Realign the wire and move the
C clips along the handrail if necessary.
9. DO NOT OPERATE the treadmill for a 24-hour period.
The adhesive on the mounting pads requires this
amount of time to bond properly.