Filter
Top Products
page 10
3. Insert the long screws through the mounting holes on
the clamp. See Diagram 7. You may need to squeeze
the ends of the clamp closer together to install the
screws. Tighten the screws using a Phillips head
screwdriver until the clamp remains securely in place.
A gap should remain between the opposite sides of
the clamp. See Diagram 7.
Note: If you have difficulty holding the clamp together,
you may want to use a C clamp (see insert on
Diagram 7) to help compress the clamp ends while
you tighten the screws.
4. Unlock and remove the mounting bracket from the
back of the electronic console. (Unlock the mounting
bracket by pushing it down toward the base of the
console.) Refer to Diagram 2 on page 6.
5. Position the mounting bracket onto the handrail clamp
so that the smooth side of the plate is facing you.
Refer to Diagram 7. Secure the mounting bracket by
inserting the two short screws. Tighten the screws
into the recessed holes on the mounting plate using
the Phillips head screwdriver. Do not over tighten the
screws because too much pressure may crack the
plastic mounting plate.
6. Unwrap the reed switch wire. The reed switch wire has
a connector on one end and the oblong-shaped reed
switch on the opposite end. Refer to Diagram 5 on
page 8.
Diagram 7
C clamp