Filter
Top Products
page 22
Diagram 17
5. Reinsert two fresh batteries. Remove the existing
batteries from the unit and reinsert two fresh (A-76
type) alkaline batteries. The positive (+) side should be
facing you. See Diagram 17.
Note: All the LCD segments momentarily appear when
the fresh batteries are installed.
6. Replace the back of the electronic console by inserting
the four Phillips head screws back into place. Tighten
the screws using the Phillips head screwdriver.
7. Reconnect the reed switch wire into the console. For
the 903 treadmill, be sure to route the wire through
the hole on the handrail clamp before reconnecting the
wire.
8. Slide the console back onto the mounting bracket.
9. Reset the display by pressing all three buttons
(SELECT, CLEAR, and SET) at the same time.
10. Press the SELECT button if you wish to turn the
electronic console ON.
+