Filter
Top Products
page 15
1. Remove the paper from the adhesive strip on the
flywheel’s foam mounting pad.
2. Wipe the back of the magnet with a dry clean, soft
cloth. Position it over the foam mounting pad on the
flywheel and press it onto the adhesive strip. Check
that it is securely mounted. See Diagram 12.
3. Wipe the base of the reed switch (the “base” is the
side opposite the ++) with a clean cloth.
CAUTION: Check the alignment of the +’s on the
reed switch with the magnet before adhering the
reed switch onto the side rail mount. For the
electronics to operate properly, the magnet can only
pass over one of the +’s on the reed switch.
4. To check the alignment between the magnet and reed
switch, move the flywheel slightly so that you can
place the base of the reed switch onto the foam
mounting pad. You should be able to see and read the
positive (+) signs. Position the reed switch between
the roller guard and deck so that the magnet passes
over one of the “+” markings on the reed switch.
Important: If the magnet passes over both “++” on the
reed switch, a false count or an erratic display can
appear on the electronic console.
Diagram 12