Filter
Top Products
Page 4
Unpacking the 718e or 723e Low Impact Climber
All Precor products are thoroughly tested and inspected before shipment. The
climber is shipped in the following pieces:
• base
• upright support (long column)
• base column support (short column)
• resistance cylinders
• handrail console
• electronic console display
• hardware kit, Owner’s Manual, and limited warranty card (not shown in
Diagram 1)
Diagram 1
Unpacking the climber.
Base column support
(short column)
USA
R
USA
R
USA
R
Base
Electronic console display
Handrail console 718e only
Handrails 723e only
Unpack the climber and place all the pieces on the floor. For help in identifying
the various pieces, refer to Diagram 1. The packet containing the hardware kit,
Owner’s Manual, and limited warranty card is not shown.
Important: Do not pinch or crimp the reed switch cable during the unpacking
and assembly process. The rope attached to the upright assembly is used to
install the reed switch cable. Do not remove the rope from the upright
assembly at this time. Do not cut the wire ties holding the stair arms to the
upright support.
Upright support (long column)
Resistance cylinders