Filter
Top Products
Page 11
Diagram 10
Attach resistance cylinder to stair arm.
Bolt
Stair arm
Nut
a. Align the resistance cylinder with the holes in the U-shaped mount
and slide the resistance cylinder into position. See Diagram 10.
b. Insert the bolt through the U-shaped mount and resistance cylinder.
Use the wrench (H) to hold the nut in place while you tighten the bolt
securely using the other wrench (H).
c. Repeat step 6 to mount the other resistance cylinder.
Resistance cylinder mount
Washer (718e only)
Bushing
U-shaped mount
Diagram 11
Install handrail for the 718e only.
Handrail console
Handrail
Upright support
CAUTION: The reed switch
cable should slide easily
through the upright support.
Do not tug on the cable
because you could void the
manufacturer’s limited
warranty.
7. Install Handrail. (Diagram 11 or 12) The 718e has a different handrail than
the 723e climber. Follow the appropriate steps below to mount the
handrails.
a. 718e Handrail. Take the two small bolts (E) from the hardware kit.
Position the handrail console (flat surface of the console should face
up) on top of the upright support and feed the reed switch cable
through the large hole in the handrail console. Tape the connector to
the top of the console. Align the bolt holes and secure the handrail
console to the frame by inserting the bolts through the top of the
handrail console and into the upright support. Tighten the bolts firmly
using the hex key (G).
Important: Pull gently on the excess cable as you feed the cable through
the large hole in the handrail console. If the cable does not move freely,
check to be sure that the cable is not pinched or crimped between the long
and short column mounts. See step 3.
Bolt (E)
Reed switch cable