Filter
Top Products
Page 27
CAUTION: Abrasive cleaners
or polishes will damage the
surface finish.
Maintenance and Troubleshooting
The climber requires little maintenance beyond periodic cleaning. Occassionally,
you will need to change the batteries when they wear down. Instructions for
these procedures are provided in this section. If you encounter problems with
the climber, refer to
Troubleshooting Tips
in this section for help.
Cleaning the Climber
Clean the climber periodically with a mild solution of detergent and water or a
general household cleaner. Wipe the surface of the console with a moist cloth
and dry with a clean towel. Never pour liquids on the electronic console.
Changing the Batteries
The electronic console comes with two “AA” alkaline batteries installed. When
your console no longer shows a digital readout or the count becomes erratic,
you need to change the batteries.
Note: Occasionally, the batteries can become dislodged, so you need to
reposition the batteries in the drawer, but not necessarily replace them.
1. Locate the drawer on the side of the electronic console and press in lightly
to open it. Refer to Diagram 15 on page 13.
2. Use your fingers to slide the drawer out and expose the battery case.
Remove the old batteries and replace them with two new “AA” alkaline
batteries. The displays light up and the console beeps.
Note: Align the batteries to the proper polarity (+ and - indicators are inside
the battery case).
3. Close the battery drawer by pushing it gently into the electronic console.
4. Press START/STOP to activate the timer (TIME display). Note that you can
press RESET to “reset” the displays to zero.
Troubleshooting Tips
Check the chart below to see if your problem is listed. If the following informa-
tion does not solve a particular problem, call your authorized Precor dealer. See
Obtaining Service
in this section for information
Problem Solution
Electronics, no display • Replace batteries. See instructions on the
previous page.
• Clean battery connections.
Electronics, no stroke count • Reed switch to magnet spacing is incorrect.
Electronic unit shuts down after 5 minutes—
see step 10 in the
Assembly Instructions
.
• Magnet placement incorrect.
• Pinched or severed cable.
Frame loose • Recheck and tighten frame and base bolts.
Squeaks • Lubricate the rope pulley mechanism.
• Lubricate resistance cylinder connectors.
• Check bolts for tightness.