Filter
Top Products
Page 13
Diagram 14
Install electronic console (718e).
Phillips-head screws
Electronic console
c. Align the holes and insert two phillips-head screws (F) on the
underside of the handrail console.
d. Tighten the screws using your phillips-head screwdriver.
Handrail console
Diagram 15
Install the batteries
9. Insert Batteries. (Diagram 15) Find the drawer on the side of the electronic
console and press in lightly to open it. Pull the drawer out with your
fingers. Take the following steps to insert the batteries:
a. Slide the drawer out to expose the battery case. Place the two “AA”
alkaline batteries (found in the hardware kit) into the case. Align the
batteries to the proper polarity (+ and - indicators are inside the
battery case). The entire display lights and the console beeps.
b. Close the battery drawer by pushing it gently into the electronic
console.
c. Press START/STOP to activate the timer (TIME display). Press RESET
to “reset” the displays to zero. For more information, refer to the
section titled,
Understanding the Electronic Console.
Battery drawer
AA battery case
USA
R