Filter
Top Products
B
39B 38
Options
Monitor Set
Sound Units Help
On/OFF
1/2
On/OFF
Monitor settings
1. In the Time of day display
scroll up or down until
OPTIONS is displayed.
2. Press OK to enter the
Options mode. EXERCISE
SET is displayed.
3. Scroll up or down until MONITOR SET is displayed.
4. Press OK to start the monitor settings. Sound is displayed.
Turning activity/button sound on/off
If you start from the Time of day display, repeat steps 1-4.
5. Press OK to start setting the sound. On/OFF starts to flash.
6. Scroll up or down to set sound On or Off. Press OK.
Activity/button sound consists of the button sound and in the Measure and
Exercise modes the following activity sounds: start, stop and lap recording,
phase start, interval phase end and recovery calculation end sounds. It does
not consist of heart rate zone alarms, watch alarm or fitness test alarm.
Selecting measuring units
If you start from the Time of day display, repeat steps 1-4.
5. Scroll up or down until Units is displayed.
6. Press OK to start setting the units. 1 or 2 starts to flash.
7. Scroll up or down to select the desired Unit. Press OK.
Naming bike 1 and bike 2
You can name the bikes with four letters, numbers or marks.
Number in the right corner indicates, which bike settings are in use.
(b0=Bike OFF, b1=Bike 1, b2=Bike 2)
1. In the Time of day display scroll up or down until OPTIONS is displayed.
2. Press OK to enter the Options mode. EXERCISE SET is displayed.
3. Scroll up or down until BIKE SET is displayed.
4. Press OK to start the bike settings.
5. Scroll up or down until Bike 1 or 2 is displayed.
6. Press and hold signal/light button. Adjustable letter is flashing.
7. Scroll up or down to select the desired mark. Press OK.
8. Repeat previous step until you have chosen all four letters.
To continue your settings, press the stop button or to return to the Time of
day display, press and hold the stop button.
S710 man GBR/B kopio.pm6 8/3/01, 14:3338-39