Filter
Top Products
STEP 2
A. Screw the threaded end of the leg cable (108) approximately 3/4" into the end of the selector
shall (115) and figh’~en [am nut securely as shown.
B. If upon completion of assembly, the head plate (117) does not sit on top of the firs]’ weight plate (67),
push the head plate down, insert the selector pin (72) and perform several repefifion;~ at the station.
This will relax the cczble system and prevent the head plated from lifting up.
C.
If after completing s’tep B. the head plate still does not sit on top of the first weight plate or if
there rs excess slack in the cable system, adiust the threaded end of the cable accordingly and
retighten the iam nuf.
_ Shroud Assembly Instructions
Use this procedure to assemble the shrouds of the ParaBody 950ST
Ao
Securely assemble the pec station shroud (51)
the pec guid~, rod support (43) and the base (15) using
four 5/8 x
blaok button head cap screws (59),
(Nofe-" The pec station shroud has no labels,)
25