Filter
Top Products
Slap 8
A.
Slide two hinge tabs (73) onto the wolff sleeve (39) and securely attach press seat pad (49)
The "hinge" part of the hinge tab
1"
two 3/B x bolts (97), and two 3/B" washers (7B). (Note:
should face upward.)
B.
Slide the right back pad angle (2) and left back pad angle (3) onto the wolff sleeve (39)
1"
attach the press back pad (50) using four 3/8
bol{s (97), and four 3/8" ~rashers (TB).
C.
Insert one 3/4 x 10-1/2" shaft (116) into the press base (13) as shown.
E.
Secure the press support tubes (40))~],ght back pad angle (2)and the left back pod angle
two 1/2" nylock nuts (82).
using two 1/2 x
bolts (87), four
flange bearings (69), and
Secure nuts, then back off 1/4 turn.)
F.
Center 3/4 x 10-1/2" shaft (116) and secure press suppoH tubes (40) using two 5/16 x 3/B"
screws
G.
Apply one rubber bumber (56) to the back of the press back pad (50) where the pad comes
contact with the rear bolt.
10