Filter
Top Products
Pec Dec Cable Assembly Instructions
Use this procedure to assemble ~he pec dec cables of the Pc~raBody 950ST
Step C
Step F & H
LAT
CABLE
Stel3 1 order, route the threaded end of the lot coble (~403~! through the top boom (20), the boise
A. ~r~5~h, iSen
d
the Icrge hole in the pec guide rod support
B.
Screw the threaded end of the lat cable (107) approximately 5/4" into the end of t’he selector
shaft (113) and tighten jam nut securely as shown.
C.
Securely assemble three 3-1/2" pulleys (111)_i~o the slots of ~he fop boom (20) using three
2-3/4" bolls (99), six 3/8" Flmnge Spacers ~14), ~nd three 3/8" nylock nu~s (83). (Note: Loop
cable ~round each pulley prior to inseffing if into the slob)
D.
Securely ~ssemble ~wo 3-1/2" pulleys (111) lnfo the slots of the base (15) using two 3/8
2-3/4" bolls (99), four 3/8" Flonge Spacers (74), and two 3/8" nylock nuts (8~{). (Note: Loop
cable around e~ch pulley prior ~o inseffing if into the slot.)
E.
securely lighten ~he bolts of the pec 9uide rod support (43) ~nd fop boom (20) connection ~f
time. (Note: Center the pec guide rod suppo~ horizontally end vertically before tightening.
F.
Apply two 1" x 1" glides (SO) to the flo~fing pulley (30), ~s shown.
G.
Securey assemble,one 4-1/2" pulle~ (110) ~o ~he flo~ting pulley stop (~2) using one 3/8 x 2-3/4"
bolt (99), two 3/8’ flange spacers (74), and one 3/8" nylock nu~ (B3).
H.
Securely assemble one 4-1/2" pulley (110),~o the flo~fing pulley (30) using 3,/8 x 2" bolt
(100), ~wo 3/8" w,=shers (78), and one 3/8 nylock nut (83). Loop cable around pulley and
flo~fing pulley (30) onto the flo~fing pulley stop (32).
"’ 18