Filter
Top Products
Step 7
A.
Loosely aftach the press arm odiu.s,,
~
(23) to the rear up.r,!gh~ (21) using two 1" pillow block
bearings (112), four 3/8 x 3-1/4 bolts (98), four 3/B’ washers (78), and
B.
Center press arm adiust (23) to I~ne up w~th ~he post on the press base (13) and securely ~ighlen
set screws on the pillow block bearings (112).
C.
Adiusl pillow block bearings (112) until the press arm ad[us~ (23) is level and securely tighten
bolls.
D.
Securely assemble one 1/2" spring pln (64) to the press arm (6) as shown.
s~u~ =.=~ ~e p~e.. ~=~) ~o ~.~ p~’" =~= ~iu~ (~) "’~ o~ ~/~ ~ ~-~/2" bo~ (~),
~wo 1/2" washers (79), ~wo 1 flange bearings (69), a,nd one 1/2" low height nylock
(Note: Securely tighten, then back nut off 1/4 turn to allow the press arm to rofcffe freely.)
r. s~u~.~y =,~h ~,~/~o~ ro~ (7) ~o ~h~ p~.,, b=~ (~3) u,~ng ~o ~/2 ~ ~" bo~, (~8), four
~o the
/z"
washers (79), and two
low height nylock nuts (84). Apply ~wo non-skid z~frips (61)
calf / low row a~s shown.
G.
AHach swivel pulley bracket (41) fo the press base (13) using one 1/2" low height nylock
(84). (Note: Securely tighten, ~hen back nu~ off 1/4 turn fo allow the swivel pulley bracket fo rotate
freely.)
11