Filter
Top Products
~3/8X1 "
-1/4
FIGURE 14
STEP 14:
¯ SECURELY assemble the CABLE (18) to the plate on the UPRIGHT FRAME (2)using one 3/8 X 1-1/4" BOLT (30), two 3/8" WASHERS
(40), and one 3/8" LOCK NUT (42). See FIGURE
¯ SECURELY ti~hten thebolts of the PULLEY BLOCK
1/2 X 5- I/2:;
FIGURE 15
STEP 15:
¯ Assemble t~vo 4 X 7" ROLI.EP, PADS (15) to the K_NEE SUPPORT (3)using t~vo STARLOCK COLLARS (46) as shown in FIGUq~E
¯ SECURELY assemble file KNEE SUPPORT (3) to the UPRIGHT FRAME (2) using one 1/2 X 5-1/2" BOLT (38) and one 1/2"
NUT (44). (NOTE: Do not overtighten this connection, the KNEE SUPPORT should rotate freely.) See FIGURE
¯ SECURELY assemble the SPRING P~’,I .AS SEa~IBLY (45) to the KNEE SUPPORT (3) as sho~al in FIGURE
¯ Auach one 1" SQ. GLIDE (21) to the UPRIGHT FRAME (2) where the round of the KNEE SUPPORT (3) makes contact.
3 4 5 6
12