Filter
Top Products
20
5. INSTALLATION ON THE WEAPON
Installation of the NC 3-12x50 on the weapon
includes mounting and gluing of the fixation rings
(Ø30mm) in accordance with the installation manual
of the ring manufacturer.
The Ø30mm fixation rings must be firmly attached
to the riflescope body with a two-componential
epoxy glue.
WARNING:
Do not over tighten fixation rings. Over tightening
can lead to deformation of the riflescope, and this
will prevent parallax adjustment mechanism to
work correctly.
If screws of the front fixation rings are tightened
with excessive force, the parallax adjustment knob
will rotate with effort. In this case it is necessary to
loosen screws of the fixation ring to restore the
normal way of parallax knob rotation.
It is recommended to allow negative inclination of
the riflescope towards the rifle barrel in the range
of 0-0.5 degrees to allow wider range of the
elevation adjustment. Such precaution will provide
longer range shooting.