Filter
Top Products
NAUTILUS
®
MAINTENANCE
CHANGING THE GAME IN HEALTH AND FITNESS
™
38
2. Test the belt by running on the belt at about 4
MPH. Hold the handrail lightly and resist the belt
movement with your feet. If walking belt slips,
repeat step 1.
Walking Belt Tracking Adjustment
Perform this procedure whenever the belt moves to
one side or the other. Stay off the belt when adjusting
the tracking.
1. Start the treadmill at minimum speed and incline.
2. Increase speed to 5 mph and make the following
adjustment:
a. If the belt moves to the right, turn the right
tension bolt ¼ turn clockwise.
b. If the belt moves to the left, turn the left tension
bolt ¼ turn clockwise.
3. After making an initial adjustment, run the
treadmill for fi ve minutes and observe how the belt
tracks. If the belt continues to move away from
the center, adjust the appropriate side as in Step 2
until properly centered.
qqqqq
IMPORTANT Do not over tighten walking
belt! The belt need only be tight enough to prevent
it from slipping during use. Excessive belt tension
will decrease belt life and can damage the treadmill
rollers and drive system.
Belt Replacement
If the walking belt becomes worn from heavy usage, it
may need to be replaced. Call an Authorized Nautilus
®
Fitness Retailer to obtain service.
Moving and Storage of Treadmill
qqqqq
IMPORTANT Treadmill is extremely
heavy and awkward and requires two people to
safely move!
1. Set the treadmill to maximum incline.
2. To avoid electrical shock, turn off the power
switch on the treadmill, then remove the treadmill
power cord from the power source before moving
the treadmill.
qqqqq
WARNING AS LONG AS THE
TREADMILL IS PLUGGED INTO A POWERED OUTLET
AND THE TREADMILL CIRCUIT BREAKER IS ON, THE
UNIT IS RECEIVING POWER, EVEN IF THE DISPLAY
IS TURNED OFF.
3. Together, lift the rear of the treadmill, then roll it
to the new site using the wheels on the front of
the treadmill.
When storing for prolonged periods, cover the
treadmill with a dust cover. Do not store in damp
areas. Do not store the treadmill on its end as it could
fall on someone.
Using After Storage Period
Before using the treadmill again after moving or
storage, check the power cord and all attachments to
be sure they are undamaged and securely connected,
then test the system for proper operation.
MAINTENANCE
T7_16-18_OM.indd 38 11/12/04 3:33:48 PM