Filter
Top Products
NAUTILUS
®
MANAGEMENT MENU
CHANGING THE GAME IN HEALTH AND FITNESS
™
36
MANAGEMENT MENU
Management Menu
To access the Management Menu, follow the
steps below.
1. Press and hold the SPEED UP and SPEED DOWN
Keys for three seconds while in Standby Mode.
2. Treadmill is now in Management Menu Mode.
TOTAL HOURS will be shown on the display, press
the ENTER Key to advance.
3. MAX SPEED will now be shown on the display and
the treadmill’s current maximum operating speed
will be displayed. To change this max speed use
the SPEED UP and SPEED DOWN Keys and press
the ENTER Key to confi rm. Note: The treadmill is
preset from the factory to its highest operating
speed. This feature should be used if the treadmill
is in an unsupervised area that a higher operating
speed could be unsafe.
4. MAX TIME will now be shown on the display and
the treadmill’s current maximum workout time will
be displayed. The time can be adjusted up or down
using the SPEED UP/DOWN Keys if you wish to
limit the maximum workout time. Press the ENTER
Key to confi rm and advance.
5. SAFETY CORD – ON will now be shown in the
display. To turn this feature off, press the SPEED
UP Key. The display will show SAFETY CORD- OFF.
This will allow the treadmill to be used without
the Safety Key in place. Press the ENTER Key to
confi rm and advance.
qqqqq
IMPORTANT If at any point the Safety
Key is put back into place this will automatically
reactivate this feature!
6. UNITS – ENGLISH will now be shown in the
display. Use the SPEED UP/DOWN Keys to select
between ENGLISH or METRIC units. Press the
ENTER Key to confi rm and advance.
7. (T7.18 Model Only) Up LCD Contrast will now be
shown in the display window. Use the SPEED UP/
DOWN Keys to adjust the display contrast for the
upper display window as needed. Default value is 7.
Press the ENTER Key to confi rm and advance.
8. (T7.18 Model Only) Low LCD Contrast will now
be shown in the display window. Use the SPEED
UP/DOWN Keys to adjust the display contrast for
the dot matrix window as needed. Default value is
7. Press the ENTER Key to confi rm and advance.
9. LANGUAGE – ENGLISH will now be shown in the
display. Use the SPEED UP/DOWN Keys to select
English, French, German or Spanish languages.
Press the ENTER Key to confi rm and advance.
10. Treadmill will now exit Management Menu Mode
and return to the Standby Mode.
T7_16-18_OM.indd 36 11/12/04 3:33:35 PM