Filter
Top Products
38
by turning clockwise until tight.You can then turn the bezel
counter-clockwise until the desired beam pattern is achieved.
Commuter Halogen Lamp
Disconnect the light head from the battery and allow lamps to
cool before removing.Orient the light head facing upward and
remove the bezel by rotating it counterclockwise.To remove
the lamp from the socket, grasp firmly with your thumb and
index finger and pull straight out. Replace lamp by aligning pins
and pressing the new lamp gently into the socket until it
reaches the base. Re-install the bezel by turning clockwise
until tight. Do not over tighten.
Note: It is extremely important to ONLY use Light & Motion
approved replacement bulbs. Failure to do so will damage the
light and void the warranty.
Vega LED
The LED used in the Vega is extremely durable and should last
for the lifetime of the light. The LED and batteries are not
designed to be removed or replaced. All service work on the
Vega system must be performed by the Light & Motion service
department. See the warranty section of these instructions for
information on contacting us with service questions.The front
bezel is not designed to be rotated or removed. Tampering or
removing the front bezel will void the warranty.