Filter
Top Products
32
Solo Logic Mv light operation
The Light & Motion Solo Logic Mv light has one switch on the
top of the head that controls power. Pushing it quickly twice
turns the light on. The light turns on in the 13w mode; pushing
the button again causes the light output to be reduced in 1/3
increments (10w and 7w respectively). The green LED on the
top of the light head displays output levels.To turn the light off
you must press and hold the button for 3 seconds.The Solo
Logic MV incorporates a “soft” start feature which allows the
user to plug a freshly charged battery into the light head
without reducing the bulbs life.
The Solo Logic Mv incorporates a Low Battery
Warning Mode.
If the battery capacity drops below a certain threshold, or
becomes discharged, the light head will automatically go into
the lowest power setting and the LED will begin to blink. This
signifies you have approximately 15 minutes of battery power
left. While in this mode the light output can be adjusted as
normal, but will significantly reduce run time. If the battery
continues to be discharged,the light head will automatically go
into the lowest power setting and the light will begin to pulse.
The green LED will flash very rapidly for one minute.The light
head will automatically shut down to preserve the battery. If
the light head shuts down it can’t be restarted until the
battery is recharged.