Life Fitness 93T Treadmill User Manual


 
3.2 HEART
RATE MONITORING
THE OPTIONAL HEART RATE CHEST STRAP
The Life Fitness Treadmill is equipped with Polar® telemetry, a heart rate monitoring system in
which electrodes, pressed against the skin, transfer heart rate signals to the treadmill console.
These electrodes are attached to a chest strap that the user wears during the workout. The chest
strap is optional. To order it, call Life Fitness Customer Support Services at 1-800-351-3737.
See the diagram below for correct positioning of the strap. The electrodes (A), which are the two
grooved surfaces on the underside of the strap, must remain wet to transmit accurately the elec-
trical impulses of the heart back to the receiver. Moisten the electrodes. Then, secure the strap
as high under the chest muscles as possible. The strap should be snug, but comfortable enough
to allow for normal breathing.
The transmitter strap delivers an optimal heart rate reading when the electrodes are in direct
contact with bare skin. However, it functions properly through a thin layer of wet clothing.
If it becomes necessary to re-moisten the chest strap electrodes, grasp the center of the strap,
pull it away from the chest to expose the two electrodes, and re-moisten them.
During the setup of a heart rate zone training workout, the user will be required to enter a start-up
speed. If a heart rate chest strap is not detected, the maximum allowable speed is 4.5 mph. If a heart
rate chest strap is detected, the maximum speed is 12 mph.
A A
20