Filter
Top Products
i_I _ )
i!l
i i i
i i
COMMONPRODUCTQUESTIONS
ARETHESOUNDSMY TREADMILLMAKESNORMAL?
All treadmills makea certain type of thumping noise clueto the belt riding over the milers,especiallynew
treadmills. Thisnoise will diminish over time, although may not totally go away.Overtime, the belt will
stretch, causing the belt to ride smootherover the rollers.
WHYIS THETREADMILLI PURCHASEDLOUDERTHANTHEONEATTHESTORE?
All fitness products seemquieterin a large store showroombecausethere is generallymorebackgroundnoise
than in yourhome.Also,there will be lessreverberationon a carpeted concretefloor than on a woodoverlay
floor.Sometimesa heavyrubber mat wifl help reducereverberationthrough the floor.If a fitness product is
placed closeto a wall, there will be morereflected noise.
WHENSHOULDI BEWORRIEDABOUTA NOISE?
As long as the soundsyour treadmill makesare no louder than a normal conversationaltone of voice, it is
considerednormal noise.
TROUBLESHOOTING-TREADMILL
Yourtreadmill is designed to be reliable and easyto use.However,if you experiencea problem, please referencethe
troubleshootingguide fisted below.
PROBLEM:Thebanding straps were
removedbeforeASSEMBLYSTEPI was
complete and the machine hassprung
openand cannotbe assembled.
$_N: Theair shockshavebeenengagedprematurely. Tocorrect this, tilt themachine on it's nosebylifting
the cleck(light end) upwards.Stepon the foot latch and folcldown the cleckso that it is horizontal. Youmaynow
proceedwith ASSEMBLYSTEPI.
PROBLEM: Theconsolecloesnot fight up and/or the belt cloesnot move.
$QLgTIQN:Verifythe following,
DOESTHEREDLIGHTONTHEON/OFFSWITCHLIGHTUP?
IF YES:
• Doublecheck that all connectionsaresecure,especially theconsolecable. Unplugand reconnectthe console
cable to verify.
• Makesure the consolecable is not pinched or damagedin any way.
• Turnthe poweroff, unplug the power cable and wait 60 seconds.Removemotorcover. Waituntil all red LED
lights havegoneoff on themotorcontrol boardbeforeproceeding.Next,verifythat noneof the wiresconnected
to the lowerboard are looseor disconnected.
IF NO:
Verifythat the outlet the machineis plugged into is functional Doublecheck that the breakerhas not tripped,
it is on a dedicated 20-amp circuit, it is not on a GFCI-equippedoutlet, and it is not plugged into a power
strip/surge protector or extensioncord.
Thepowercorclis not pinched or damaged and is properlyplugged into the outlet ANDthe machine.
Thepowerswitch is turned to the ONposition.