Filter
Top Products
BEFORE
YOU BEGIN
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 7A S S E M B LY S T E P 6
A) M5x20mm Screw
quantity:4
B) M5x15mm Screw
quantity:8
quantity:6
D) M8x15mm Screw
quantity: 2
C) 29mm wave washer
FOOTPADWASHER (F)SCREW (G) FOOTPAD BRACKET
PEDAL ARM
LINK ARM
A) Open HARDWARE BAG FOR STEP 6.
B) Place WASHER (F) over the LINK ARM axle.
C) Slide LINK ARM into PEDAL ARM.
D) Attach FOOTPAD BRACKET to the LINK ARM with 3 SCREWS (G).
E) Repeat on other side.
STEP 5
A) M5x20mm Screw
quantity:4
B) M5x15mm Screw
quantity:8
quantity:6
D) M8x15mm Screw
quantity: 2
C) 29mm wave washer
LOWER HANDLEBAR
SPACER RING (G)
SPACER (H)
BOLT (I)
WASHER (K)
NUT (J)
LOWER LINK ARM
SPACER
SPACER RINGS
LOWER
HANDLEBAR
A) Open HARDWARE BAG FOR STEP 7.
B) Insert SPACER (H) into the LOWER HANDLEBAR. Place SPACER RINGS (G) on both sides of SPACER (H), slide
LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
C) Insert BOLT (I) into LOWER HANDLEBAR and secure using NUT (J) and WASHER (K).
D) Repeat on other side.
SCREW (E)
20 mm
Qty: 4
SCREW (F)
15 mm
Qty: 8
WAVE WASHER (F)
20 mm
Qty: 2
SCREW (G)
15 mm
Qty: 6
HARDWARE BAG FOR STEP 6 CONTENTS :
SPACER RING (G)
Qty: 4
SPACER (H)
Qty: 2
BOLT (I)
45 mm
Qty: 2
NUT (J)
Qty: 2
WASHER (K)
Qty: 2
HARDWARE BAG FOR STEP 7 CONTENTS :
E800 SHOWN
E500-E800_Rev.1.7.indd 12-13 4/27/07 1:43:53 PM