Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 2
MAIN FRAME
REAR STABILIZER
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
SCREW (B)
A) Open HARDWARE BAG FOR STEP 2.
B)
Secure
REAR STABILIZER
to
MAIN FRAME
using 2
SCREWS (B).
NOTE: Make sure holes are aligned before inserting SCREWS.
SCREWS (B)
30 mm
Qty: 4
HARDWARE BAG FOR STEP 2 CONTENTS :
CONSOLE WIRES
TOP COVER
CONSOLE MAST
GROMMET
MAIN FRAME
BOLTS (C)
LOCK WASHERS (D)
A S S E M B LY S T E P 3
A) Open HARDWARE BAG FOR STEP 3.
B) Slide the GROMMET and TOP COVER over the CONSOLE MAST.
C)
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D) Attach
CONSOLE MAST
to
MAIN FRAME
using 7 BOLTS (C) and 7 LOCK WASHERS (D)
.
E) Slide GROMMET and TOP CAP down to seal the MAIN FRAME.
BOLTS (C)
15 mm
Qty: 7
LOCK WASHER (D)
13.5 mm
Qty: 7
HARDWARE BAG FOR STEP 3 CONTENTS :
* NOTE: Be careful not to
pinch any wires while
assembling the mast.
E500-E800_Rev.1.7.indd 8-9 4/27/07 1:43:48 PM