Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 5A S S E M B LY S T E P 4
NOTE: There is NO hardware bag for this step.
A) Slide LOWER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure LOWER HANDLEBAR to CONSOLE MAST using
PRE-ATTACHED SET SCREWS.
B) Slide UPPER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure UPPER HANDLEBAR to CONSOLE MAST using PRE-ATTACHED SET SCREWS.
C) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
PRE-ATTACHED SCREWS
TAB
UPPER HANDLEBAR
HANDLEBAR JOINT
LOWER HANDLEBAR
NOTCH
SCREW (E)
20 mm
Qty: 4
SCREW (E)
15 mm
Qty: 8
SCREW (G)
29 mm
Qty: 6
SCREW (H)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 5 CONTENTS :
STEP 5
A) M5x20mm Screw
quantity:4
B) M5x15mm Screw
quantity:8
quantity:6
D) M8x15mm Screw
quantity: 2
C) 29mm wave washer
SCREW (E)
LOWER LINK ARM
FOOTPAD
A) Open HARDWARE BAG FOR STEP 5.
B) Attach FOOTPAD to LOWER LINK ARM using 4 SCREWS (E).
C) Repeat on other side.
E800 SHOWN
E500-E800_Rev.1.7.indd 10-11 4/27/07 1:43:50 PM