Filter
Top Products
BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
RIGHT LOWER LINK ARM
U-BRACKET
SPLIT TEFLON WASHERS (I)
FLAT WASHER (J)
BOLT (K)
CONNECTING TUBE
SPACER (H)
RIGHT PEDAL ARM
Open HARDWARE BAG FOR STEP 7.
Align the U-BRACKET on the RIGHT LOWER LINK ARM with the CONNECTING TUBE on the RIGHT
PEDAL ARM.
Slide the SPACER (H) through the U-BRACKET and the CONNECTING TUBE so that it can no longer
rotate.
Insert 2 SPLIT TEFLON WASHERS (I) between the CONNECTING TUBE and the U-BRACKET.
Secure the joint with a FLAT WASHER (J) and BOLT (K).
Repeat on the other side.
A
B
C
D
E
F
SPLIT TEFLON
WASHER (I)
28 mm
Qty: 4
SPACER (H)
72 mm axis
Qty: 2
FLAT WASHER (J)
35 mm
Qty: 2
BOLT (K)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 7 CONTENTS :
A SS E M B LY ST E P 7 A SS E M B LY ST E P 8
SPACER RINGS (M)
LOWER HANDLEBAR
NUT (P) FLAT WASHER (O)
BOLT (N)
LOWER LINK ARM
SPACER (L)
Open HARDWARE BAG FOR STEP 8.
Slide SPACER (L) into LOWER LINK ARM.
Snap 2 SPACER RINGS (M) onto both sides of SPACER (L). While
holding SPACER RINGS (O), slide LOWER LINK ARM into bottom
end of LOWER HANDLEBAR.
Insert 1 BOLT (N) into LOWER HANDLEBAR and secure using 1
WASHER (O) and 1 NUT (P).
Repeat on other side.
A
B
C
D
E
BOLT (N)
45 mm
Qty: 2
SPACER (L)
Qty: 2
SPACER RING (M)
Qty: 4
WASHER (O)
18 mm
Qty: 2
NUT (P)
18 mm
Qty: 2
HARDWARE BAG FOR STEP 8 CONTENTS :
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
E1201_Rev.1.4.indd 14-15 7/29/08 10:37:42 AM