Filter
Top Products
BEFORE
YOU BEGIN
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A SS E M B LY ST E P 5
PRE-ATTACHED WASHERS
RIGHT HANDLEBAR
PRE-ATTACHED SCREWSCONSOLE MAST
PRE-ATTACHED WASHER & BOLTHANDLEBAR COVER
HANDLEBAR CAP
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
Remove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.
Slide RIGHT HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED WASHER &
BOLT.
Remove PRE-ATTACHED SCREWS from RIGHT HANDLEBAR.
A
B
C
After handlebars are assembled they will rotate freely – be cautious. Until
the machine is fully assembled, do not grab the handlebars for support.
WARNING
Attach HANDLEBAR COVERS with PRE-ATTACHED SCREWS.
Slide HANDLEBAR CAP onto top of RIGHT HANDLEBAR with the slanted side facing the rear of the
elliptical (as shown).
Repeat on other side.
D
E
F
A SS E M B LY ST E P 6
SCREWS (F)
WASHERS (G)
LINK ARM
FOOTPAD
Open HARDWARE BAG FOR STEP 6.
Attach FOOTPAD to LINK ARM using 4 SCREWS (F) and 4 WASHERS (G).
Repeat on other side.
A
B
C
WASHER (G)
18 mm
Qty: 8
SCREW (F)
16 mm
Qty: 8
HARDWARE BAG FOR STEP 6 CONTENTS :
E1201_Rev.1.4.indd 12-13 7/29/08 10:37:35 AM