Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
BOLTS (A)
FRONT STABILIZER TUBEMAIN FRAME
A SS E M B LY ST E P 1
Open HARDWARE BAG FOR STEP 1.
Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
A
B
A SS E M B LY ST E P 2
BOLTS (B)
SPRING WASHERS (C)
FLAT WASHERS (D)
CONSOLE MAST BOOT
CONSOLE CABLE MAIN FRAME
BOLTS (B)ARC WASHERS (E)
CONSOLE MAST
BOLT (B)
15 mm
Qty: 6
SPRING WASHER (C)
15 mm
Qty: 6
FLAT WASHER (D)
18 mm
Qty: 4
ARC
WASHER (E)
17 mm
Qty: 2
angle view
WATER
BOTTLE
HOLDER
CONSOLE
MAST
PRE-ATTACHED
SCREW
BOLT (A)
20 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
Open HARDWARE BAG FOR STEP 2.
Slide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST above bolt holes as shown above.
Carefully pull the CONSOLE CABLE through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
Attach the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (B), 2 SPRING WASHERS (C) and 2
FLAT WASHERS (D) in each side and 2 BOLTS (B), 2 SPRING WASHERS (C) and 2 ARC WASHERS (E) in
the front of the CONSOLE MAST. Slide CONSOLE MAST BOOT down to cover MAIN FRAME.
DO NOT PINCH WIRES!
Attach the WATER BOTTLE HOLDER to the mast using 2 PRE-ATTACHED SCREWS.
A
B
C
D
E
HARDWARE BAG FOR STEP 2 CONTENTS :
E1201_Rev.1.4.indd 8-9 7/29/08 10:37:27 AM