Filter
Top Products
BEFORE
YOU BEGIN
6
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Before proceeding, find your elliptical’s serial
number located on the front stabilizer tube and
enter it in the space provided below. Also locate the
model name which is located on the mast boot.
ENTER YOUR SERIAL NUMBER AND
MODEL NAME IN THE BOXES BELOW:
There are several areas during the assembly process of an elliptical that
special attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If
the assembly instructions are not followed correctly, the elliptical could
have frame parts that are not tightened and will seem loose and may
cause irritating noises. To prevent damage to the elliptical, the assembly
instructions must be reviewed and corrective actions should be taken.
A S S E M B LY
SERIAL NUMBER :
MODEL NAME :
* Refer to the SERIAL NUMBER and MODEL NAME when calling for service.
* Also enter this serial number on your Warranty Card.
WARNING
TOOLS INCLUDED PARTS INCLUDED
c 5mm Allen Wrench
c Phillips Screw Driver
c 13/15mm Flat Wrench
c 5mm T Wrench
c 1 Console
c 1 Console Mast
c 1 Console Mast Boot
c 1 Front Stabilizer Tube
c 2 Handlebars (left & right)
c 2 Handlebar Caps
c 2 Handlebar Cover Sets
c 2 Lower Link Arms
c 2 Pedal Arms
c 2 Pedal Arm Covers
CONSOLE
RIGHT HANDLEBAR
MULTI-GRIP BARS
LOWER LINK ARM
PEDAL ARM COVER
ELBOW COVER
PULSE GRIPS
CONSOLE MAST
DISPLAY
PIVOTING FOOT PAD
PEDAL ARM
c 2 Elbow Covers
c 1 Multi-Grip Bars
c 2 Pivoting Foot Pads
c 1 Water Bottle Holder
c 6 Hardware Bags
c 3 iPod
®
Dock Inserts
c 1 Universal MP3 Player Dock Insert
c 1 iPod
®
Docking Station Rubber Plug
c 1 Audio Adaptor Cable
c 1 Power Cord
WATER BOTTLE HOLDER
POWER CORD SOCKET
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com
HANDLEBAR COVER SETS
FRONT STABILIZER TUBE
CONSOLE MAST BOOT
LEFT HANDLEBAR
HANDLEBAR CAP
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recommended
that you place a protective covering on your floor. During each assembly step, ensure that ALL nuts and
bolts are in place and partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike
grease is recommended.
E1201_Rev.1.4.indd 6-7 7/29/08 10:37:20 AM